Chip inductors known appearance mount inductors and other chip components (SMC and SMD), is suitable for outdoor mounting technology (SMT) is a new generation of short lead times, or lead-free microelectronic devices. Connector soldered surface in the same plane. Chip inductors, and to perform micro-inductor is often more difficult to achieve sufficient inductance and quality (Q), because the magnetic components in the circuit together with the magnetic circuit, the production process is relatively simple, the three non-A source root element chip inductors, capacitors and resistors behind. In electronic devices, we often see many magnetic and chip inductors http://www.dglangxun.com/diangan/ device, forming a bridge cable (wire and cable as the magnetic induction coil wound several times), commonly used in electronic circuit fault a component, a good high-frequency noise shielding effect, called the absorbent ring, as this information is normally used ferrite, ferrite beads called (abbreviated ring). Wound Chip Inductors and stacked in two ways. The former is the traditional winding inductor miniaturization of products, which uses the multilayer laminated printing technology and consumer process, smaller chip inductors wound volume ratio of the inductance type focused on developing products and services. Dongguan Long flood Electronics Main products are: SMD electrolytic capacitors http://www.dglangxun.com/dianjiedianrong/ chip tantalum capacitors http://www.dglangxun.com/tandianrong/ chip capacitors http://www. dglangxun.com / dianrong / Power Inductors http://www.dglangxun.com/gonglvdiangan/ Chip Resistor http://www.dglangxun.com/dianzu/